Skil 3386-01 Manuel d'utilisation et d'entretien télécharger pdf (Page 4)

Specific Safety Rules for Band Saws

1. To avoid injury from unexpected movement, make

sure the saw is on a firm, level surface, properly

secured to prevent rocking. Make sure there is

adequate space for operations. Bolt the saw to a

support surface to prevent slipping or sliding

during operation.

2. Turn off and unplug the saw before moving it.

3. Use the correct size and style of blade.

4. Make sure the blade teeth point down and toward

the table.

5. Blade guide, supports, bearings, and blade

tension must be properly adjusted to avoid

accidental blade contact and to minimize blade

breakage. To maximize blade support, always

adjust the upper blade guide and blade guard so

that it barely clears the workpiece.

6. The table tilt lock handle should be tight.

7. Use extra caution with very large, very small, or

awkward workpieces.

8. Use extra supports to prevent workpieces from

sliding off the table top.

9. Workpieces should be secured so they don’t twist,

rock, or slip while being cut.

10. Plan intricate or small work carefully to avoid

pinching the blade. Avoid awkward operations

and hand positions to prevent accidental contact

with the blade.

11. Small pieces should be secured with clamps or

fixtures. Do not hold small pieces with your hand

because your fingers might go under the blade

guard.

12. Support round work properly (use a V block or

press it against the miter gauge) to prevent it from

rolling and the blade from biting.

13. Cut only one workpiece at a time. Make sure the

table is clear of everything except the workpiece

and its guides before you turn the saw on.

14. Always watch the saw run before each use. If

there is excessive vibration, saw blade stuttering,

or unusual noise, stop immediately. Turn the saw

off. Unplug it immediately. Do not start the saw

again until the problem has been located and

corrected.

15. To free any jammed material, turn the switch off.

Remove the switch key and unplug the saw.

Wait for all moving parts to stop before removing

the jammed material.

16. Do not leave the work area until all moving parts

have stopped. Shut off the power to master

switches. Remove the switch key from the band

saw and store it in a safe place, away from

children. Childproof the workshop!

17. Maintain proper adjustment of blade tension,

blade alignment, blade guides and thrust

bearings.

18. Adjust upper guide to 1/8” above workpiece

before cutting.

19. Hold workpiece firmly against table.

20. Use recommended blade and speed for

workpiece material.

21. Before, starting, be certain the motor, table,

attachments and adjustment knobs are secured.

22. Do not operate with wheel cover door open.

23. Unplug saw before making blade changes,

adjustments or repairs.

24. Do not expose to rain or use in damp locations.

SM 2610028633 01-13_SM 2610028633 01-13.qxp 1/9/13 7:24 AM Page 4

1 2 3 4 5 6 7 8 9 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Skil 3386-01 Manuel d'utilisation et d'entretien Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Skil 3386-01