Skil 1400-02 Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9.;*=2707<=;>,=287<

Thank you for purchasing the Skil Multi-Tasker.

This tool was designed to tackle a wide

variety of Skil Multi-Tasker projects. The Skil

Multi-Tasker tackles tasks that are tedious,

time consuming or simply next to impossible

to achieve with any other tool. The

ergonomic housing is designed for you to

hold and control in a comfortable manner

during operation.

It comes with an assortment of accessories

that are specifically designed for remodeling

work where you need precision and control.

Your Skil Multi-Tasker has a robust electric

motor, is comfortable in the hand, and is

made to accept a large variety of accessories

including flush cut blades, scraper blades,

grout removal wheels and sanding pads.

Accessories come in a variety of shapes and

permit you to do a number of different jobs.

As you become familiar with the range of

accessories and their uses, you will learn just

how versatile your Skil Multi-Tasker.

Visit www.Skil.com to learn more about what

you can do with your Skil Multi-Tasker

#$"

This Skil Multi-Tasker Tool is intended for dry

sanding of surfaces, corners, edges, for

scraping, for sawing soft metals, wood and

plastic components, and for grout removal

using the applicable tools and accessories

recommended by Skil (See page 13).

7=;8->,=287

!#$"##

Getting the most out of your oscillating tool is a

matter of learning how to let the speed and the

feel of the tool in your hands work for you.

The first step in learning to use the tool is to

get the “feel” of it. Hold it in your hand and feel

its weight and balance (Fig. 3). Depending on

the application, you will need to adjust your

hand position to achieve optimum comfort and

control. The unique comfort grip on the body of

the tool allows for added comfort and control

during use.

When holding tool, do not cover the air vents

with your hand. Blocking the air vents could

cause the motor to overheat.

 !## Practice on scrap material first

to see how the tool’s high-speed action

performs. Keep in mind that your tool will

perform best by allowing the speed, along with

the correct accessory, do the work for you. Be

careful not to apply too much pressure.

Instead, lower the oscillating accessory lightly

to the work surface and allow it to touch the

point at which you want to begin. Concentrate

on guiding the tool over the work using very

little pressure from your hand. Allow the

accessory to do the work.

Usually it is better to make a series of passes

with the tool rather than to do the entire job

with one pass. To make a cut, for example,

pass the tool back and forth over the work. Cut

a little material on each pass until you reach

the desired depth.

-9-

FIG. 3

SM 1619X05148 01-11:SM 1619X05148 01-11 1/10/11 2:25 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire