Skil 3100 Manuel d'utilisateur télécharger pdf (Page 6)

c. Once the user sets one leg at the desired height, follow the

same steps for the remaining three legs.

4. Adjustable Foot – for Leveling Bench

If you are working in an area that is not level, we have provided

a solution. We have an adjustable foot that will extend 1.75”

inches to level your bench (Fig. 6).

Before operating make sure the entire unit is

placed on a solid, flat, level surface.

Serious

injury could occur if tool is unstable and tips.

5. Opening the Cut Channel

Cut channel must be fully open for sawing.

. To open your cut channel there are four latches you need to

open first.

b. Unlock the four latches by pulling them upward and extend the

table outward (Fig. 7).

Do not use the dog holes to pull the table

outward. Once the table is extended, the

latches MUST be locked in order to use the cut channel

correctly.

Failure to lock the latches while the table is in the open

position could cause the table top to move while cutting, which can

result in misaligned cuts or personal injury.

Use only with 7-1/4” or smaller circular saws.

Larger size saws may be able to cut thru brackets.

he cut channel is 2-3/4” deep and can be used with a

aximum 7 -1/4” Circular Saw. The cutting channel can be used

for cross cuts or rip cuts. The user must secure the work piece

with the wedge dogs provided or other clamping devices (Fig. 8).

Do not rip parallel to X-Bench dogs,.

6. Wedge Dogs

Dog holes are throughout the table top surface and are meant to

hold work pieces in place while cutting (Fig. 9). Two wedge dogs

come with the X-Bench. These dogs are made specifically for the

X-Bench. Note feed direction while cutting in wedge dog position.

Blank insert plate must be in table top during top applications.

See

reference guide figure 28 for hole pattern identification of

wedge dogs.

7. Miter Saw Mounting

There are three mounting holes that support most miter saw

dimensions (Fig. 10). If you use a miter saw on this table, we

require you mount the miter saw to the X-Bench for safety. Note:

close cut channel for miter saw use.

Fig. 6

Fig. 5

Pin is not

depressed = leg

is not secured in

locked position

WARNING

27 28

38 39 40

46 47 48

Fig. 7

Latch is now in the

locked position.

Latch is now in the

open position.

Fig. 8

Fig. 9

Fig. 10

WARNING

Direction

of Cut

Direction

of Cut

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Skil 3100 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Skil 3100