Skil 3100 Manuel d'utilisateur télécharger pdf (Page 5)

1. Opening the X-Bench

he X-Bench comes in the folded position and no assembly is

equired. In order to open the X-Bench, the user must pull and

twist the main knob, located by the handle, to the open position (Fig. 1a).

b. After the table has been opened, the knob must be turned back

into the locked position before extending the legs or placing the

table upright. To lock the table in place, twist the main knob back

into the closed position. Once the main knob is in the closed

position, the user can now safely extend the legs and then place

the table upright.

Table lock must be in the locked position, the

bench may collapse in use if not fully locked.

(Fig. 1b).

2. Extending the Legs

Once the table is opened and the main knob is in the locked

position, the user can now extend the legs of the work station.

While the table is on its side or inverted, extend the legs completely

and make sure the leg braces are straightened and locked. The

pin will lock in place to ensure that the leg brace is fully secured

(Fig. 2).

3. Adjusting Leg Height

ith the table still on its side or inverted, the user can adjust the

able height to his/her preference. In order to adjust the table

height the user must:

b. Fully open the leg locking lever. By positioning the lever in the

open position (Fig. 3), it will allow the user to adjust the leg to a

esired height marked on the leg. After the leg is positioned at a

desired height, the user must close the lever locking mechanism to

half way and allow the pin to snap into the lock position. You can

visually make sure the pin is depressed correctly and ensure the

leg cannot slide at this point. (Fig. 4).

If the pin is not depressed into the hole, the leg clamp will be very

difficult to close. Damage may occur to the leg clamp if too much

force is applied without the pin being in the correct location.

Each leg lock pin must be fully engaged and

clamped fully closed before use.

Table may

collapse if leg locks are not secure..

Table must be level and stable for use. If the

lever does not close completely or is difficult to

depress, this means the pin is not in the correct location. You

MUST adjust the leg to position the pin into the correct height

marking (Fig. 5). Close the clamp fully with pin in hole before use.

Table must be level and stable for use.

WARNING

Fig. 1a

Pins are not

engaged in

hole, unit is

ow open.

Fig. 1b

Pins are

engaged in

hole, the

table is now

locked.

Using Your X-Bench Work Station – No Assembly Required

Fig. 2

Pin is shown in the

locked position.

WARNING

Fig. 4

Pin is fully

depressed = leg

is locked in

position

Fig. 3

WARNING

1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Skil 3100 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Skil 3100

Produits connexes et manuels pour Non Windsor P1700120