Skil 2250 Manuel d'utilisateur télécharger pdf (Page 9)

3=-988/->,+>>/<C:+-5

0<97>996,/09</ 7+5381

+8C+==/7,6C+.4?=>7/8>=9<-2+81381

+--/==9<3/=. Such preventive safety

measures reduce the risk of starting the tool

accidentally.

#"$$#

Move reverse switch lever to the center “OFF”

position. Remove battery pack and rotate the

clutch ring to the drill bit symbol

“ ”. Rotate the chuck sleeve counter-

clockwise viewing from chuck end, and open

chuck to approximate drill bit diameter. Insert

a clean bit up to the drill bit flutes for small bits,

or as far as it will go for large bits. Close chuck

by rotating the chuck sleeve clockwise and

securely tighten by hand (Fig. 2).

989> ?=/>2/:9A/<90

>2/ .<366 A236/ 1<+=:381

-2?-5>9699=/89<>312>/8,3> Friction burn

or hand injury is possible if attempting to grasp

the spinning chuck.

-9-

==/7,6C

!

WARNING

!

WARNING

" &%

Rotate the clutch ring to the drill bit

symbol “ ”. Open the chuck all the way,

remove left-hand thread screw inside chuck by

turning it clockwise (Fig. 2).

Insert the short arm of a 3/8" hex key wrench

and close jaws on flats of wrench. Strike long

arm of wrench sharply counterclockwise,

remove wrench and unthread chuck from

spindle.

#$%

Always keep the spindle threads, the threads

of the chuck and securing screw free of debris.

To install a chuck, reverse “re moving the

chuck” procedure.

&"#! $" 

$""#'$

Your tool is equipped with a variable speed

trigger switch. The tool can be turned "ON" or

"OFF" by squeezing or releasing the trigger.

The speed can be adjusted from the minimum

to maximum nameplate RPM by the pressure

you apply to the trigger. Apply more pressure

to increase the speed and release pressure to

decrease speed (Fig. 1).

 "'""&"#

&"$"" 

After tool use, lock trigger in

“OFF” position to help prevent

accidental starts and accidental discharge.

Your tool is equipped with a forward/

reversing lever and trigger lock located above

the trigger (Fig. 6). This lever was designed

for changing rotation of the bit, and for locking

the trigger in an “OFF” position.

For forward rotation, (with chuck pointed

away from you) move the lever to the far left.

For reverse rotation move the lever to the far

right. To activate trigger lock move lever to

the center off position.

989>-2+81/.3</->39890

<9>+>398?8>36>2/>996-97/=

>9+-97:6/>/=>9:Shifting during rotation of

the chuck can cause damage to the tool.

!

CAUTION

!

WARNING

:/<+>3818=><?->398=

clockwise

Counter

clockwise

CHUCK

SLEEVE

CHUCK

COLLAR

FIG. 2

SM 1619X04086 04-09:SM 1619X04086 04-09 5/5/09 9:40 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire