Skil 3310 Manuel d'utilisateur télécharger pdf (Page 26)

26.

If you are making a rip type cut in thinner materials, the facing

should be attached to the fence so that the bottom edge touches

he top surface of the table. In this situation, the facing must be

lower than the fence. This will prevent thin material from sliding

under the rip fence.

When positioning fence 14 for maximum rip

cutting (without table extension), make sure side

of fence housing (a) is even with the side edge of the table 2. Do

not make rip cuts or dado cuts beyond this position because the

fence can not be properly locked. Maximum rip cut capacity is

10 3/4 inches (Fig. 4).

15. SMART GUARD SYSTEM

Consists of three key elements: Adjustable (3 position) Riving

Knife, Anti-Kickback Device, and Barrier Guard Device. All of these

are part of a modular system that requires no tools to assemble or

unassemble. This Guard System must always be in place and

working properly for all thru-sawing cuts.

16. TABLE INSERT

Is removable for removing or installing blade or other cutting tools.

For your own safety, turn switch “OFF” and

remove plug from power source before re moving

insert.

To remove the insert:

A. Lower the blade below the table surface.

B. Remove main barrier guard and anti-kickback device.

C. Raise blade guard.

D. Lift insert from pocket in table using finger hole.

Never operate the saw without the proper insert in place. Use the

saw insert when sawing, and the dado insert when da do cutting.

17. MITER GAUGE

Head can be locked in desired position for crosscutting or mitering

by tightening the lock handle. ALWAYS SECURELY LOCK IT

WHEN IN USE.

Notches are provided in the miter gauge 17 for attaching an

AUXILIARY FACING (b) to make it easier to cut longer pieces. Be

sure facing does not interfere with the proper operation of the saw

blade guard.

Select a suitable piece of smooth straight wood 3/4" thick, drill two

holes through it and attach it with two round head #10 or #12 round

head screws 1-1/4" long (c) (Fig. 6).

NOTE: When bevel crosscutting, attach facing so that it extends to

the right of the miter gauge and use the miter gauge in the groove

to the right of the blade.

Getting To Know Your Table

Saw (Continued)

WARNING

FIG. 6

Maximum 10 3/4”

FIG. 4

FIG. 5

SM 2610008289 02-10:3310 Table Saw 2/2/10 8:38 AM Page 26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

Skil 3310 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Skil 3310